Scientific Atlanta DPX120 Operations Instructions download pdf (Page 15)

15

TCP/IP Configuration, continued

5. Click Options in the TCP/IP window, and

then click Active in the TCP/IP Options

window.

Note: In some cases, the Load only when

needed option will not appear. If it appears,

select the option. A check mark appears in the

option.

6. Verify that the Use 802.3 option located in

the upper right-hand corner of the TCP/IP

window is unchecked. If there is a check

mark in the option, deselect the option, and

then click Info in the lower left-hand corner.

7. Is there a Hardware Address listed in this

window?

• If yes, click OK. To close the TCP/IP

Control Panel window, click File, and

then scroll down to click Close. You have

completed this procedure.

• If no, you must power down your

Macintosh.

8. With the power off, simultaneously press

and hold down the Command (Apple),

Option, P, and R keys on your keyboard.

Keeping those keys pressed down, power on

your Macintosh. The computer will start, and

you will hear the Apple chime; do not release

these keys.

9. Continue pressing these keys for up to

three chimes, then release the keys and

allow the computer to restart.

10. When your computer fully reboots, repeat

steps 1 through 7 to verify that all TCP/IP

settings are correct. If your computer still does

not have a Hardware Address, contact your

authorized Apple dealer or Apple technical

support center.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 25 26

Comments to this Manuals

No comments